FAQ: How To Add Curls To A Deco Mesh Wreath?

How do you make a curled ribbon wreath?

1. Cut 6 pieces of ribbon (2 of each color) 24″ in length and knot in the center.
2. Use scissors to make the ribbon curly.
3. Place a push pin into the center of the knot and place into the wreath form.
4. Continue until the entire wreath form is covered.

How long do you cut mesh for a wreath?

Cut your 10″ mesh into 18 inch strips. For a 15-24″ Premade Work Form you ‘ll need 18 pieces of the mesh. Ruffle each piece of the 10″ mesh and insert one ruffle into each twist tie. Using your EZ Bow Maker, make a large bow for the wreath.

Can you cut deco mesh in half?

Set your deco mesh on a hard, heat-safe surface. Do not cut the mesh with scissors. Simply measure out how much you want to cut, then set it down on a hard, heat-safe surface. If you need to, draw a ” cutting ” guideline with a marker across the mesh. You don’t want to cut the mesh because it will fray.